Our production lines allow us to manufacture unlimited quantities of the following products
I. Request for the manufacturing of the product.
Make a request to the CEO of “KAUCHUK” about the possibility of manufacturing of a batch of specefied items. This request must contain the terms and planned volumes of production. The application must be accompanied by a full package of design documentation or sketch product specification. In fact of receiving the request we appoint the representative of the customer, which will not only be a bridge between you and the experts of JSC “KAUCHUK”, but will plan, track and implement all further work until a final satisfactory result.
II. Preliminary evaluation of the request for manufacturing.
Commission of the plant experts considers received information, clarifies the missing data. After a preliminary assessment of the feasibility and advisability of launching a new project experts issued their preliminary conclusion about the possibility of manufacturing.
III. Approval of preliminary results with the customer.
The representative of the customer sends pre-trial detention to a query for approval or further details.
IV. Signing the contract.
When satisfying both sides solution is found, contract draft will be submitted to you for approval and signing.
V. Design, approval of the design documentation.
VI. Manufacturing, matching samples of new products.
VII. Manufacturing, approval of pilot batch.
VIII. Starting of serial production.
Here is a brief description of the process. In reality, this time-consuming process requires precise detail. But we have considerable experience with the launch of new products into production and are ready for new tasks at the level specified by our customers.
up to 50 mPa (static application) and up to 32 MPa (dynamic application) in mineral oils, fuel oils, emulsions, lubricants, fresh water and sea water;
up to 40 MPa (static application) and up to 10 MPa (dynamic application) with compressed air.
O-rings are made of the following groups of accuracy:
1 – for dynamic application (made by agreement with the manufacturer)
2 – for static and dynamic application
Search of the O-ring is on its designation:
(010 -…) The first three digits indicate the diameter of the surface (stem), which is put on the ring – 10mm.
(…- 014 -…) The second three numbers mean surface diameter (cylinder), in which the ring is inserted – 14mm.
(…- 25) The last two digits indicate the diameter of the cross section of the rings are 2.5 mm multiplied by 10.
So the actual size of the O-ring may be slightly different from the designation: interior towards reduction, outside, the contrary, increasing.
Description: 010-014-25 Size: 9.7х14.7х2.5mm.
Three types of seals depending on design and current pressure values:
Type 1 – for pressure 0,1-50 MPa (1,0-500 kg/cm2)
Type 2 – for pressure 0,25-32 MPa (2,5-320 kg/cm2)
Type 3 – for pressure 1,0-50 MPa (1,0-500 kg/cm2)
Type 2 cuffs are interchangeable with Type 3.